Altronix eFlow4NX8D Installation Instructions Manual do Utilizador

Power Supply/ChargersInstallation GuideModels Include:eFlow4N/eFlow4NX- 4 amp @ 12VDC or 24VDCeFlow4N8/eFlow4NX8 eFlow4N8D/eFlow4NX8D- 4 amp @ 12VDC

- 10 - eFlow4N SeriesNEC Power-Limited Wiring Requirements for eFlow4NX Models:Power-limited and non power-limited circuit wiring must remain separat

eFlow4N Series - 11 -Enclosure Dimensions (BC300) (approximate H x W x D):eFlow4N, eFlow4N8, eFlow4N8D13.5” x 13” x 3.25” (342.9mm x 330.2mm x 82.55

- 12 - eFlow4N Series1.5”(38.1mm)1.5”(38.1mm)1.5”(38.1mm)5.0”(127.0mm)5.0”(127.0mm)1.5”(38.1mm)2.0”(50.8mm)2.0”(50.8mm)1.75”(44.45mm)1.75”(44.45mm)4.

eFlow4N Series - 13 -Appendix A - UL Listed Compatible DevicesA.1 Four (4) Wire Smoke DetectorsTable A-1 below lists four (4) wire smoke detectors c

- 14 - eFlow4N SeriesNotes:

eFlow4N Series - 15 -Notes:Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.140

CUT ALONG DOTTED LINEPower Supply/Chargers Operating GuideModels Include:ModelInput120VAC, 60HzOutputPower-LimitedAuxiliary Power-LimitedOutput (unswi

- 2 - eFlow4N SeriesOverview:The eFlow4N power supply/chargers convert a 120VAC / 60Hz input to a 12VDC or 24VDC nominal output(see Power Supply Conf

eFlow4N Series - 3 -Specifications:Installation Instructions:Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/NFPA 72

- 4 - eFlow4N Series10. Trigger terminals are end of a line resistor supervised (10k ohms). Opening or shorting trigger terminals will cause [DC

eFlow4N Series - 5 -Terminal Identification:Power Distribution ModuleTerminal LegendPD8UL/PD8ULCBFunction/Description1P to 8P Positive DC power outp

- 6 - eFlow4N SeriesPower Distribution Module(s):Fig. 3a - PD8UL Power Distribution Board Fig. 3b - PD8ULCB - Power Distribution BoardNCOMMON POWE

eFlow4N Series - 7 -LGNNCCNONCCNOBAT FAILAC FAIL--- DC +ACAC1DC--- BAT +– AUX +TRIGGER EOLSUPERVISED5A 250VRESETGND NOOPEN --- 24VCLO

- 8 - eFlow4N SeriesNEC Power-Limited Wiring Requirements for eFlow4N Models:Power-limited and non power-limited circuit wiring must remain separated

eFlow4N Series - 9 -PD8UL/PD8ULCBDC Output to devices(refer to Fig. 3a or 3bfor board configuration pg. 6)DoorWire Strap(fromEnclosureto Door)Batter